|
|
This is a modified AeroModel mount for an Actro 40-5 on my ¼ scale Cub |
|
|
I cut off a glass-filled .60 size motor mount and mounted an aluminum plate to accept a Astro 40. |
|
|
A .60 size conversion using a glass-filled mount with 2 4-40 all-thread straps around a Aveox 1415-2Y. |
|
|
A easy to build mount using a sheet of .060 aluminum and thick wall tubing. |
|
|
Another shot showing the mount using a sheet of .060 aluminum and thick wall tubing. |
|
|
I used a combo of 4 brass struts mounted off the front of the motor and a rear clamp that is used to adjust the thrust angle. Mounted on an Arizona Models DR-1. |
|
|
This Ken Willard Pool Boy floatplane uses a film canister to house a speed 280 motor and help keep it dry. |
|
|
Another Graupner Gee Bee fitted with a 400F using thick wall aluminum tubing. |
|
|
A Graupner Gee Bee fuse and wing showing a custom mount for a Brushless 800e Outrunner Motor by PJS. |
|
|
This is 4 all-thread rods attached to an aluminum plate at the motor and thru-bolted to the firewall. This took a bit to setup but it was easily adjustable for centering and thrust. This is a Kyosho Gee Bee-Z |
|
|
A mount for a Hacker C50 series motor. The sides are off an AeroModel mount and new front plate was constructed. Two side struts were added to cut down on the vibration. |
|
|
A nice mount using the AeroModel mount on another purple motor. This is a unique adaptation to a profile fuse using two angled aluminum brackets. |
|
|
My old HiperBipe with an Aveox mounted to a Tom Hunt belt drive. This unit is monted on two glass-filled mounts. |
|
|
My Magic flying with an Aveox 1400 series with a custom .040 aluminum mount. |
|
|
The Optima-Pro has a removable plastic nose cone and no firewall. I was able to fit a geared Astro 05 into the nose by creating this unique wood mount. |
|
|
You are looking at my ¼ scale L-19BirdDog still in my hanger waiting to be finished. I’m using a plywood box along with an AeroModel mount to hold a Plettenberg HP 370-40 motor. |
|
|
This is my Ricochet that I converted from gas. I’m using a Plettenberg HP 300/30 direct drive. I bent up a couple pieces of .040 strips of aluminum to hold the motor from pulling out of its socket. |
|
|
Sports Aviation STA 40 converted to electric. An AXI 2820-10 using a 3s-2p Li-Poly battery. Using aluminum tubing, cap screws and t-nuts make great standoffs. |
|
|
This is a speed 400 and Maxon gearbox combo mounted in a modified Sunbird from Skybench.com |
|
|
Another Aveox motor mounted to a ModelAir-Tech belt drive, hanging from a glass filled mount. |
|
|
A hard hit damaged the AeroModel mount, motor and gearbox from Hacker, most of which is toast! |
|
|
A Phasor 45-3 on a Dymond plastic mount, must be strong it survived the crash! |